MITSUBISHI FX3G-2AD-BD Manual FX3G-2AD-BD INSTALLATION MANUAL

MITSUBISHI inverter FR-A740 series.
Voltage level: 3 phase 400V.
Frequency converter capacity: 0.75KW.
FR-A700 converter products are suitable for all kinds of high load requirements of the equipment.
Such as lifting, lift, printing and dyeing, printing and dyeing, material coiling and other general occasions FX3G-2AD-BD Manual FX3G-2AD-BD INSTALLATION MANUAL.
High level driving performance.
Unique sensorless vector control mode,
A wide variety of mechanical equipment can be operated at high precision in the super low speed region without the need of the encoder FX3G-2AD-BD
With torque control mode,
And in the speed control mode can use the torque limit function.
With vector control function (with encoder),
Frequency converter can achieve position control and fast response, high precision speed control (zero speed control, servo lock, etc FX3G-2AD-BD Manual FX3G-2AD-BD INSTALLATION MANUAL. ) and torque control. Memory format: flash memory.
Number of steps: up to 64000 steps.
Battery support: do not.
Write, delete method: installed on the PLC through the peripheral devices to write, delete.
Note: with program transfer function. Input output cable for A6TBXY36 type connector / terminal row conversion module FX3G-2AD-BD Manual FX3G-2AD-BD INSTALLATION MANUAL.
Length 3M. Max input / output points: 20 points.
Power supply voltage: DC24V.
Input points: 12 points.
Output points: 8 points.
Output type: relay.
Power consumption (W): 20.
Weight (kg):0.4.
Size (WxHxD) mm:75x90x75.
Positioning and pulse output functions: a PLC cell can output 2 point 100KHz pulses at the same time.
PLC is equipped with 7 special positioning instructions,
Including zero return, absolute or relative address expression and special pulse output control.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The serries transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor FX3G-2AD-BD Manual FX3G-2AD-BD INSTALLATION MANUAL.
The series PLC can not be brought with the expansion module, but can be installed by the BBD board to extend a small amount of I/O FX3G-2AD-BD Manual FX3G-2AD-BD INSTALLATION MANUAL.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication.