MITSUBISHI FX2N-1RM-E-SET Manual FX2N-1RM-E-SET User's Manual

Analog input expansion board (2 channel).For FXCPU direct connection.Power: 11kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity FX2N-1RM-E-SET Manual FX2N-1RM-E-SET User's Manual.
At the same time the installation options in the use of 75kW and above motor FX2N-1RM-E-SET (the IP55 series has a built-in DC reactor.)
According to the motor power used to select the DC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 450KW FX2N-1RM-E-SET Manual FX2N-1RM-E-SET User's Manual.
The main circuit of the inverter can be divided into two categories in general: voltage type is the voltage source of the DC converter for AC inverter,
The filtering of the DC circuit is the capacitance; the current mode is the DC conversion of the current source to the AC inverter,
The DC loop filter is the inductor.
Why is the frequency of the inverter voltage proportional to the change?
The electromagnetic torque of any motor is the result of the interaction between the current and the magnetic flux, the current is not allowed to exceed the rated value, otherwise it will cause the heating of the motor FX2N-1RM-E-SET Manual FX2N-1RM-E-SET User's Manual.
Therefore, if the magnetic flux decreases, the electromagnetic torque will decrease, which leads to the reduction of the load carrying capacity. Total input and output points: 16 points.
Output points: 16 points.
Output type: silicon controlled output.
FX Series in the compact body built in superior performance, and strive to operate simple.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application.
Can be extended to all models in the FX series analog devices.
Function extension board, special adapter without programming can be used for communication.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basiic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect FX2N-1RM-E-SET Manual FX2N-1RM-E-SET User's Manual.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V FX2N-1RM-E-SET Manual FX2N-1RM-E-SET User's Manual.
The number of connection points depends on the basic unit and the expansion unit.