MITSUBISHI FX1S-10MT-ESS/UL Manual FX1S-10MT-ESS/UL PROGRAMMING MANUAL II

MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 0.75kw.
SLD converter rated current: 7.7A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight) FX1S-10MT-ESS/UL Manual FX1S-10MT-ESS/UL PROGRAMMING MANUAL II FX1S-10MT-ESS/UL
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the volume of equipment).
For applications that require high torque at low speeds, the HD rating is the most suitable FX1S-10MT-ESS/UL Manual FX1S-10MT-ESS/UL PROGRAMMING MANUAL II.
The controller is used to control and monitor the frequency converter through the network.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps. MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 90KW.
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes FX1S-10MT-ESS/UL Manual FX1S-10MT-ESS/UL PROGRAMMING MANUAL II.
For the requirements of relatively high precision, even if the load changes are also required to operate at a given speed of the occasion,
Inverter with PG feedback function can be used (selection).
If the given acceleration time is too short, the output frequency of the inverter is far more than the change of the speed (electric angular frequency),
Converter will be due to flow over the current trip, the operation stopped, whhich is called stall FX1S-10MT-ESS/UL Manual FX1S-10MT-ESS/UL PROGRAMMING MANUAL II. Input points: 32 points.
Connected programmable logic controller: FX1NC, FX2NC, FX3UC.
Weight: 0.2KG.
FX2NC expansion module can be directly connected to the FX1NCC, FX2NC, PLC FX3UC on the expansion of the input and output FX1S-10MT-ESS/UL Manual FX1S-10MT-ESS/UL PROGRAMMING MANUAL II.
Do not need to connect the cable and so on, therefore can carry on the compact expansion.