MITSUBISHI FX1S-10MT-D Manual FX1S-10MT-D HARDWARE MANUAL

MITSUBISHI inverter series: FR-F842.
Voltage level: three phase 400V.
Power: 450kw.
SLD converter rated current: 962A.
Structure and function: the rectification part is off type.
Type: CA.
Substrate coating: have.
Energy saving by high efficiency motor.
Reduce standby power consumption.
DC24V external power supply, the input MC signal can be stopped after the motor for the OFF, in the motor drive for the ON FX1S-10MT-D Manual FX1S-10MT-D HARDWARE MANUAL FX1S-10MT-D
Standby power management can be carried out by means of frequency converter to realize the power consumption reduction of standby time.
According to the temperature of the inverter cooling fan, the operation of the inverter can be controlled.
According to the operating conditions of the inverter cooling fan output the corresponding signal,
Therefore, the inverter and other built-in fan and inverter cooling fan synchronous operation FX1S-10MT-D Manual FX1S-10MT-D HARDWARE MANUAL.
Can reduce the power consumption in the stop. MITSUBISHI inverter FR-A740 series.
Voltage level: 3 phase 400V.
Frequency converter capacity: 250KW.
Frequency converter is the application of frequency conversion technology and micro electronics technology, by changing the motor operating power frequency mode to control the AC motor power control equipment FX1S-10MT-D Manual FX1S-10MT-D HARDWARE MANUAL.
The converter is composed of rectifier (AC), filter, inverter (DC), braking unit, driving unit, micro processing unit of the detection unit.
Inverter by the internal IGBT to adjust the output power supply voltage and frequency,
According to the actual needs of the motor to provide the required power supply voltage, and then achieve the purpose of energy saving, speed control, in addition to the,
Inverter has a lot of protection functions, such as over current, over voltage, overload protection and so on. Needle number: 40.
Specification: Cable flat cable connector, supporting 2 sets. FX1S-10MT-D Manual FX1S-10MT-D HARDWARE MANUAL. Power: 15kw.
Purpose: to suppress the power harmonics.
Connected to the inverter input, can be used to improve the power factor, reduce the input side of the high harmonic current.
According to the mmotor power used to select AC reactor FX1S-10MT-D Manual FX1S-10MT-D HARDWARE MANUAL.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.)