MITSUBISHI FX1N Series CE FX1N Series EC Declaration Of Conformity

Power: 2.2kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FX1N Series CE FX1N Series EC Declaration Of Conformity.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FX1N Series
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor FX1N Series CE FX1N Series EC Declaration Of Conformity.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output.Power: 55kw.
Voltage: 400V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor FX1N Series CE FX1N Series EC Declaration Of Conformity.
Can also be connected without built-in brake transistor inverter.
Three types of discharge resistors are available.
Please select according to the required braking torque. Memory format: flash memory.
Number of steps: up to 64000 steps.
Battery support: do not.
Write, delete method: installed on the PLC through the peripheral devices to write, delete. MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 30kw.
SLD converter rated current: 154A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight).
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the voolume of equipment) FX1N Series CE FX1N Series EC Declaration Of Conformity.
For applications that require high torque at low speeds, the HD rating is the most suitable.
The controller is used to control and monitor the frequency converter through the network FX1N Series CE FX1N Series EC Declaration Of Conformity.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps.