MITSUBISHI FX-PCS-VPS/WIN-E Manual FX-PCS-VPS/WIN-E SOFTWARE MANUAL

Power: 7.5kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FX-PCS-VPS/WIN-E Manual FX-PCS-VPS/WIN-E SOFTWARE MANUAL.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FX-PCS-VPS/WIN-E
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor FX-PCS-VPS/WIN-E Manual FX-PCS-VPS/WIN-E SOFTWARE MANUAL.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Input points: 8 points.
Output points: 6 points.
Power supply voltage: AC100-240V.
Output type: transistor output (source).
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance FX-PCS-VPS/WIN-E Manual FX-PCS-VPS/WIN-E SOFTWARE MANUAL.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. Output points: 16 points.
Transistor output large current. Max input / output points: 20 points.
Power supply voltage: 24VDC.
Input points: 12 points.
Output points: 8 points.
Output type: relay.
Power consumption (W): 7.
Weight (kg):0.3.
Size (WxHxD) mm:75x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O.
The series 1N through the installation of BD series PLC boarrd, can achieve RS232, RS485, RS422 communication FX-PCS-VPS/WIN-E Manual FX-PCS-VPS/WIN-E SOFTWARE MANUAL.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, thhe output points are less than 14 FX-PCS-VPS/WIN-E Manual FX-PCS-VPS/WIN-E SOFTWARE MANUAL.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator.