MITSUBISHI FX-16NT Manual FX-16NT USER'S GUIDE

Power: 15kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity.
At the same time the installation options in the use of 75kW and above motor FX-16NT Manual FX-16NT USER'S GUIDE. (the IP55 series has a built-in DC reactor FX-16NT)
According to the motor power used to select the DC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Use: power cord for basic unit.
Length: 1.0m.
Auxiliary parts for FX3GC and FX3UC. MITSUBISHI inverter series: FR-F842.
Voltage level: three phase 400V FX-16NT Manual FX-16NT USER'S GUIDE.
Power: 500kw.
SLD converter rated current: 1094A.
Structure and function: the rectification part is off type.
Type: CA.
Substrate coating: have.
Energy saving by high efficiency motor.
Reduce standby power consumption.
DC24V external power supply, the input MC signal can be stopped after the motor for the OFF, in the motor drive for the ON.
Standby power management can be carried out by means of frequency converter to realize the power consumption reduction of standby time FX-16NT Manual FX-16NT USER'S GUIDE.
According to the temperature of the inverter cooling fan, the operation of the inverter can be controlled.
According to the operating conditions of the inverter cooling fan output the corresponding signal,
Therefore, the inverter and other built-in fan and inverter cooling fan synchronous operation.
Can reduce the power consumption in the stop. Output points: 32 points
Output form: Transistor (drain type).
Connection status: connector.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points. Total points: 40 points.
Input points: 24 points.
Output points: 16 points.
Voltage: AC220V.
Outtput type: relay FX-16NT Manual FX-16NT USER'S GUIDE.
Outline dimension: 130*75*90.
FX1N series is a very powerful micro PLC,
Can be extended to up to 128 I/O points,
And can increase the special function module or the expansion board.
Communicatioon and data link function options make FX1N in the volume, communication and special function modules and other important applications is very perfect FX-16NT Manual FX-16NT USER'S GUIDE.