MITSUBISHI FR-F720-7.5K Manual FR-F720-7.5K TECHNICAL MANUAL

Display: 7 segment digital display + icon display.
Can monitor, change the value of software components.
Can also be simple to operate, change the value.
Equipped with a button operation can be used (operator certification function) and control through the PLC control function,
Can be used with the function expansion board FR-F720-7.5K Manual FR-F720-7.5K TECHNICAL MANUAL.
Can be installed directly to the FX3S, FX3SA, no wiring FR-F720-7.5K Signal level: the DC5V, 12V, and 24V differential output can be connected to the DC5V terminal by connecting terminals.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
Can be single phase, dual phase 50kHz hardware counter high-speed input.
High speed uniform output function with hardware comparison circuit FR-F720-7.5K Manual FR-F720-7.5K TECHNICAL MANUAL.
In the dual phase count, 1, 2, and 4 multiplication modes can be set.
Can be licensed and reset by PLC or external input.
Differential output type encoder. Power: 30kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function FR-F720-7.5K Manual FR-F720-7.5K TECHNICAL MANUAL. Input points: 8 points.
Output points: 6 points.
Power supply voltage: AC100-240V.
Output type: relay output.
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance.
Special adaptor and function expansion board can be installed and used FX3 series.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 55kw.
SLD converter rated current: 316A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
PID target value can be set directly from the operator panel. Flexible change settings.
In the 1 inverter, through the PID control of parallel connection pump (up to 4 units) can adjust the amount of water and so on.
1 pumps driven by parallel connection of the pump machine, in addittion to the pump for power frequency drive FR-F720-7.5K Manual FR-F720-7.5K TECHNICAL MANUAL.
The number of power frequency driven pump, according to the automatic adjustment of water.
The liquid crystal panel options (FR-LU08) can be converted too a more intuitive display unit% units FR-F720-7.5K Manual FR-F720-7.5K TECHNICAL MANUAL.
Through the use of wind, temperature and other familiar units can be simple to maintain and adjust the display.