MITSUBISHI FR-F540J-0.4K to 15K (F) Detailed Manual FR-F540J-0.4K to 15K (F) INSTRUCTION MANUAL

Input / output type: DC input (drain / source).
Input points: 8 points.
Input and output points: 8 points.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms FR-F540J-0.4K to 15K (F) Detailed Manual FR-F540J-0 FR-F540J-0.4K to 15K (F)4K to 15K (F) INSTRUCTION MANUAL.
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis.
Extended function expansion board and special adapter,
Data links and communication with external serial devices.
FX2N extension module FR-F540J-0.4K to 15K (F) Detailed Manual FR-F540J-0.4K to 15K (F) INSTRUCTION MANUAL.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V.
The number of connection points depends on the basic unit and the expansion unit FR-F540J-0.4K to 15K (F) Detailed Manual FR-F540J-0.4K to 15K (F) INSTRUCTION MANUAL. Total points: 14 points.
Input points: 8 points.
Output points: 6 points.
Voltage: AC220V.
Output type: relay.
Outline dimension: 60*75*90.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment. Can be isolated to obtain DC24/48/100V, AC100/200V input signal.MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 90KW.
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes.
For the requirements of relatively high precision, even if the load changes are also required to operate at a given speed of the occasionn,
Inverter with PG feedback function can be used (selection) FR-F540J-0.4K to 15K (F) Detailed Manual FR-F540J-0.4K to 15K (F) INSTRUCTION MANUAL.
If the given acceleration time is too short, the output frequency of the inverter is far more than thhe change of the speed (electric angular frequency),
Converter will be due to flow over the current trip, the operation stopped, which is called stall FR-F540J-0.4K to 15K (F) Detailed Manual FR-F540J-0.4K to 15K (F) INSTRUCTION MANUAL.