MITSUBISHI FR-E540-7.5K-CH Manual FR-E540-7.5K-CH TECHNICAL MANUAL

Max input / output points: 10 points.
Supply voltage: 100 - 240VAC.
Input points: 6 points.
Output points: 4 points.
Output type: Transistor (source).
Power consumption (W): 6.
Weight (kg):0.22.
Size (WxHxD) mm:60x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types FR-E540-7.5K-CH Manual FR-E540-7.5K-CH TECHNICAL MANUAL.
This type of PLC is mainly used in all of the digital input, digital output control point of the device FR-E540-7.5K-CH
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O FR-E540-7.5K-CH Manual FR-E540-7.5K-CH TECHNICAL MANUAL.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication. Extended power supply for CPU module with built-in power supply.
Bus conversion module is required when using. Maximum can be connected to 2 sets. Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output FR-E540-7.5K-CH Manual FR-E540-7.5K-CH TECHNICAL MANUAL. Max input / output points: 48 points.
Supply voltage: 100 - 240VAC.
Input points: 24 points.
Output points: 24 points.
Output type: transistor.
Power consumption: 50VA.
Weight (kg):0.85.
Size (WxHxD) mm:182x90x87.
Note recording function, Component annotation can be recorded in the program register.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to proteect your program FR-E540-7.5K-CH Manual FR-E540-7.5K-CH TECHNICAL MANUAL.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application off the continuous scan time FR-E540-7.5K-CH Manual FR-E540-7.5K-CH TECHNICAL MANUAL.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).