MITSUBISHI FR-A846-00310-2-60 PLC FUNCTION Manual FR-A846-00310-2-60 Programming Manual

Power: 7.5kw.
Voltage: 200V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connected without built-in brake transistor inverter.
Three types of discharge resistors are available FR-A846-00310-2-60 PLC FUNCTION Manual FR-A846-00310-2-60 Programming Manual.
Please select according to the required braking torque FR-A846-00310-2-60 Adapter for thermocouple temperature sensor (FX3U- - racy -BD)Max input / output points: 30 points.
Supply voltage: 100 - 240VAC.
Input points: 16 points.
Output points: 14 points.
Output type: Transistor (source).
Power consumption (W): 21.
Weight (kg):0.45.
Size (WxHxD) mm:100x90x75.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14 FR-A846-00310-2-60 PLC FUNCTION Manual FR-A846-00310-2-60 Programming Manual.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0 FR-A846-00310-2-60 PLC FUNCTION Manual FR-A846-00310-2-60 Programming Manual.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment. Power: 11kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling FR-A846-00310-2-60 PLC FUNCTION Manual FR-A846-00310-2-60 Programming Manual.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between thhe short circuit chip, in addition to connecting the DC reactor FR-A846-00310-2-60 PLC FUNCTION Manual FR-A846-00310-2-60 Programming Manual.
The installation of thermal relay, to avoid overheating and burn the braking resistor.