MITSUBISHI FR-A840-00620-2-60 PLC FUNCTION Manual FR-A840-00620-2-60 Programming Manual

Input expansion board (DC24V 4)
(FX1S and FX1N host general). MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 2.2kw.
SLD converter rated current: 16.7A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation FR-A840-00620-2-60 PLC FUNCTION Manual FR-A840-00620-2-60 Programming Manual FR-A840-00620-2-60
(rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same time, used in the control of the external machine FR-A840-00620-2-60 PLC FUNCTION Manual FR-A840-00620-2-60 Programming Manual.
No external PID controller is used to control the external machine, so the system cost can be reduced. MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 15KW.
When the inverter is running, the starting current and starting torque of the motor are how?
With the operation of the inverter, with the acceleration of the motor to improve the frequency and voltage,
The starting current is limited to 150% below the rated current (according to the different types of aircraft, 125%~200%) FR-A840-00620-2-60 PLC FUNCTION Manual FR-A840-00620-2-60 Programming Manual.
Starting with power frequency power supply, the starting current is 6~7 times of the rated current, therefore, the impact on the mechanical and electrical.
The inverter drive can be smoothly start (start time longer).
The starting current is 1.2~1.5 times of the rated current, and the starting torque is 70%~120% rated torque;
For the inverter with the torque automatic enhancement function, the starting torque is more than 100%, which can start with full load. Power: 3.7kw.
Voltage: 200V.
Purpose: high frequency braking resistor FR-A840-00620-2-60 PLC FUNCTION Manual FR-A840-00620-2-60 Programming Manual.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connectedd without built-in brake transistor inverter FR-A840-00620-2-60 PLC FUNCTION Manual FR-A840-00620-2-60 Programming Manual.
Three types of discharge resistors are available.
Please select according to the required braking torque.