MITSUBISHI FR-A7NM Manual FR-A7NM TECHNICAL MANUAL

Analog input expansion board (2 channel).
Can be installed in FX1N, PLC FX1S, providing 2 channel analog input of the board.
Because it is embedded in the PLC installation, so do not need to install space.
Can be mixed with the use of voltage input and current input. Input points: 8 points.
Output points: 6 points FR-A7NM Manual FR-A7NM TECHNICAL MANUAL.
Power supply voltage: AC100-240V.
Output type: transistor output (drain) FR-A7NM
A free combination of PLC.
FX3G basic unit: 14/24/40/60 point.
FX3GA is a compact PLC, simple design and with the basic functions of the FX3 series.
Through the strengthening of the built-in function and flexible expansion, expanded in various fields of application.
Third generation standard model.
High flexibility FR-A7NM Manual FR-A7NM TECHNICAL MANUAL.
Suitable for small scale control of high cost.
Control points to 128 points, the use of CC-Link remote I/O can control the maximum 256 points.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. RS-232C communication adapter FR-A7NM Manual FR-A7NM TECHNICAL MANUAL.
(need FX1N-CNV-BD).
(FX1S and FX1N host general). Memory format: EPROM.
Number of steps:
Can use up to 16000 steps.
Battery support: do not.
Method of writing and deleting: write and use ROM to write, use ultraviolet ray to delete. Total input and output points: 8 points.
Output points: 8 points.
Output type: transistor output.
FX Series in the compact body built in superior performance, and strive to operate simple.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application.
Can be extended to all models in the FX series analog devices.
Function extension board, special adapter without programming can be used for communication.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply frrom the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect FR-A7NM Manual FR-A7NM TECHNICAL MANUAL.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V FR-A7NM Manual FR-A7NM TECHNICAL MANUAL.
The number of connection points depends on the basic unit and the expansion unit.