MITSUBISHI FR-A740-45K-CHT BASIC Manual FR-A740-45K-CHT INSTRUCTION MANUAL

Input points: 32 points
Input mode: DC24V (drain / source).
Connection status: connector.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points FR-A740-45K-CHT BASIC Manual FR-A740-45K-CHT INSTRUCTION MANUAL FR-A740-45K-CHT Output: 16 points.
Function: relay output.
Corresponding models: FX3GA, FX3G, FX3GE, FX3GC, FX3U, FX3UC.
Can carry on the FX3GC, the FX3UC basic unit and the expansion module or the localization module the connector and the terminal station transformation,
Save the time of the input and output connection, realize the labor saving FR-A740-45K-CHT BASIC Manual FR-A740-45K-CHT INSTRUCTION MANUAL.
The use of built-in input and output components models,
Can receive AC100V input, or through the relay or the transistor to drive large capacity load. Axis of control: 1.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
7 operating modules required for easy positioning control are provided FR-A740-45K-CHT BASIC Manual FR-A740-45K-CHT INSTRUCTION MANUAL.
Type of instruction, please refer to the list in front of you.
One can control a shaft.
FX3U, PLC FX2N can connect up to 8 units,
PLC FX2NC can connect up to 4 units,
PLC FX3UC can connect up to 7 units, so that it can control more than one independent axis.
Maximum can output 100kHz pulse train.
Positioning control through the control program. Power: 15kw.
Voltage: 400V.
The surge voltage of the motor can be suppressed when the 400V motor is driven by a frequency converter.
Motor suitable for 5.5 to 37kW. Power: 22kw.
Purpose: to suppress the power harmonics.
Connected to the inverter input, can be used to improve the power factor, reduce the input side of the high harmonic current.
According to the motor power used to select AC reactor.
(when the inverter capacity is greater than the motor cappacity, is still based on the motor capacity to choose FR-A740-45K-CHT BASIC Manual FR-A740-45K-CHT INSTRUCTION MANUAL. ) Can monitor and change the value of the soft component. Can also be simple to operate, change the data.
Can display Japanese andd english FR-A740-45K-CHT BASIC Manual FR-A740-45K-CHT INSTRUCTION MANUAL.
Can be installed directly to the PLC, no wiring.
In addition, the use of FX3U-7DM-HLD, can be directly installed on the electrical cabinets.