MITSUBISHI F1 series Manual F1 series Programming Manual

Function: CPU module (internal service power supply).
Input and output points: 32 points.
Power supply capacity (DC5V power): 900mA.
Power supply capacity (DC24V service power supply): 400mA.
Input / output mode: DC input (drain / source) / transistor (drain).
Input points: 16 points.
Output points: 16 points F1 series Manual F1 series Programming Manual.
The new expansion module is more convenient!
Pioneer products with advanced built-in functions and rich extensibility F1 series
FX5U built-in analog, communication, high speed input and output,
By extending the board and adapter can be easily extended system.
In addition, through the high speed system bus,
Can maximize the role of the built-in intelligent functions of the expansion device.
DOS/V computer (D-SUB 9 pin)Control mode: 2 position control, PID control (with self tuning), PI control F1 series Manual F1 series Programming Manual.
Control operation period: 500ms.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
2 pass temperature input and 2 channel transistor output,
1 modules can be 2 systems for temperature regulation.
Single module to support PID (with self tuning), 2 position control, PI control F1 series Manual F1 series Programming Manual.
Can be detected by the current detector (CT) is out of line. Max input / output points: 30 points.
Power supply voltage: 24VDC.
Input points: 16 points.
Output points: 14 points.
Output type: relay.
Power consumption (W): 8.
Weight (kg):0.35.
Size (WxHxD) mm:100x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O.
The series 1N through the installation of BD seriies PLC board, can achieve RS232, RS485, RS422 communication F1 series Manual F1 series Programming Manual.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, thhe output points are less than 14 F1 series Manual F1 series Programming Manual.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator.