MITSUBISHI AJ71BR11 Manual AJ71BR11 Reference Manual

MITSUBISHI PLC hardware implementation
Hardware implementation is mainly for the control cabinet and other hardware design and field construction.
Design control cabinet and the operating table and other parts of the electrical wiring diagram and wiring diagram.
Electrical interconnection diagram of each part of the design system AJ71BR11 Manual AJ71BR11 Reference Manual .
According to the construction drawings of the site wiring, and carry out a detailed inspection AJ71BR11
Because the program design and hardware implementation can be carried out at the same time,
So the design cycle of the MITSUBISHI PLC control system can be greatly reduced. Cable 1.2m for the expansion of the floor, the expansion of a floor for every 1 units.Applicable models:
AJ65VBTS - - - type AJ71BR11 Manual AJ71BR11 Reference Manual .
AJ65VBTCE - - - type.
AJ65VBTCU - - - type.
AJ65ABTP - - - type.
AJ65VBCU- - type.
AJ65SBT-CLB type. Adapter for mounting rails. CPU unit.Input type: DC input, positive common end.
Input points: 16 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/7mA.
External connection: 2~4 line type.
Waterproof connector type.
Strong waterproof type of IP67 protection grade AJ71BR11 Manual AJ71BR11 Reference Manual .
No need to stop the system can be replaced module.
Without the use of tools can be a simple connection, save time.
Terminal resistor built-in.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. Input type: DC input, positive public end / negative public end.
Input points: 16 points.
Enter the response time: 10ms the following.
Rated input voltage / current: DC24V/5mA.
Output form: relay output.
Ouutput points: 16 points AJ71BR11 Manual AJ71BR11 Reference Manual .
OFF leakage current: -.
Output protection function: No.
Rated load voltage / current: DC24V/AC240V/2A.
External connection: 1 line /1 line type.
A2C shape terminal.
Type of input and output terminal AJ71BR11 Manual AJ71BR11 Reference Manual .
Shape and A2C input and output modules are identical (same mounting dimensions),
Machining and installing holes are not required.