MITSUBISHI A970GOT-SBA-EU Manual A970GOT-SBA-EU User's Manual

32: terminal line adapter 0.3mm2 (AGW22).Optional features of memory card (Q/QnA/A/FX compatible).
8MB extended memory.
Applicable models: A985 (-V) /975/970/A960GOT (-B) /A956WGOT. Input type: DC input, positive public end / negative public end.
Input points: 32 points.
Enter the response time: 0.2ms below, below 1 A970GOT-SBA-EU Manual A970GOT-SBA-EU User's Manual. 5ms, 5ms below, 10ms the following A970GOT-SBA-EU
Rated input voltage / current: DC24V/7mA.
External connection: 1 wire.
According to the external connection mode and the external equipment input and output specifications,
Choose from a rich product lineup.
Finger protection through the upper part of the terminal,
The human body will not be exposed to live parts,
Therefore, the terminal station type remote I/O module can be directly mounted to the machine tool A970GOT-SBA-EU Manual A970GOT-SBA-EU User's Manual. Input type: DC input, negative public end.
Input points: 16 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/7mA.
External connection: 2~4 line type.
Waterproof connector type.
Strong waterproof type of IP67 protection grade.
No need to stop the system can be replaced module.
Without the use of tools can be a simple connection, save time A970GOT-SBA-EU Manual A970GOT-SBA-EU User's Manual.
Terminal resistor built-in.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. Axis of control: 1.
A1SD75 series components show the MITSUBISHI in the manufacture and design of CNC, frequency converter,
Integrated technical experience in servo systeem and PLC A970GOT-SBA-EU Manual A970GOT-SBA-EU User's Manual.
These components have a wealth of features that are sufficient to meet the highest requirements in the application of positioning control.
Up to 3 axis linkage operation,
In low cost mootion control applications, this component can be used to control the operation of a multi - to 3 axis, which can be used to account for only one slot A970GOT-SBA-EU Manual A970GOT-SBA-EU User's Manual.