MITSUBISHI A80BDE-J61BT13 For SW2DNF-CCLINK Manual A80BDE-J61BT13 User's Manual

JEMANET (OPCN-1) interface unit from the station.
The response time of PLC is the interval between the time of the change of the external output signal of the PLC and the time of the change of the external output signal which is controlled by it,
Lag time, this is the time constant of the input circuit,
The time constant of the output circuit, the arrangement of the user statement and the use of the instruction,
The cycle scan mode of PLC and the way of PLC to refresh the I/O and so on A80BDE-J61BT13 For SW2DNF-CCLINK Manual A80BDE-J61BT13 User's Manual A80BDE-J61BT13
This phenomenon is called the I/O delay time effect.
Input status and input information input from the input interface,
CPU will be stored in the working data memory or in the input image register.
And then combine the data and the program with CPU A80BDE-J61BT13 For SW2DNF-CCLINK Manual A80BDE-J61BT13 User's Manual.
The result is stored in the output image register or the working data memory,
And then output to the output interface, control the external drive. Input type: DC input, positive public end / negative public end.
Input points: 32 points.
Enter the response time: 0.2ms below, below 1.5ms, 5ms below, 10ms the following.
Rated input voltage / current: DC24V/7mA A80BDE-J61BT13 For SW2DNF-CCLINK Manual A80BDE-J61BT13 User's Manual.
External connection: 1 wire.
According to the external connection mode and the external equipment input and output specifications,
Choose from a rich product lineup.
Finger protection through the upper part of the terminal,
The human body will not be exposed to live parts,
Therefore, the terminal station type remote I/O module can be directly mounted to the machine tool. Input type: DC input, negative public end.
Input points: 8 points.
Enter the response time: 1.5ms the following.
Rated input voltage / current: DC24V/7mA.
Output form: transistor output, source.
Output points: 8 points.
OFF leakage current: 0.3mA.
Output protection function.
Rated load voltage / current: DC24V/1.0A.
External connection: /2 line 2~4 line type.
Waterproof connector type.
Strong waterproof type of IP67 protection grade.
No need to stop the system can be replaced module.
Without the use of tools can be a simple connection, save time.
Terminal resistor built-in.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation methhod is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too guarantee the timeliness A80BDE-J61BT13 For SW2DNF-CCLINK Manual A80BDE-J61BT13 User's Manual A80BDE-J61BT13 For SW2DNF-CCLINK Manual A80BDE-J61BT13 User's Manual.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.