MITSUBISHI A1SCPU-S1 Manual A1SCPU-S1 User's Manual

Output type: transistor output, drain type.
Output points: 16 points.
OFF leakage current: 0.25mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.5A.
External connection: 2 wire.
Waterproof connector type.
Strong waterproof type of IP67 protection grade.
No need to stop the system can be replaced module A1SCPU-S1 Manual A1SCPU-S1 User's Manual.
Without the use of tools can be a simple connection, save time A1SCPU-S1
Terminal resistor built-in.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness A1SCPU-S1 Manual A1SCPU-S1 User's Manual.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. Twisted pair cable.
Single bus.
Remote I/O station.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program A1SCPU-S1 Manual A1SCPU-S1 User's Manual.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc.. Cable length: 6CM.
For functional connectivity (horizontal extension) GOT (D-sub 25 male and) RS422 cable pins: (D-sub 25 female pins:) connection. Interface: RS232C.
Transmission distance: 15 meters.
A1SJ71UC24-R2/R4/PR computer commmunication components can communicate with PLC, such as computers and other external intelligent devices, and the components are as follows:
Full / half duplex transmission A1SCPU-S1 Manual A1SCPU-S1 User's Manual.
4 special communication protocools A1SCPU-S1 Manual A1SCPU-S1 User's Manual.
No protocol and bidirectional mode.
Protocol selection switch function.
The optional baud rate, the highest 19.2K.
Since the echo diagnostic test.